Farmall & IHC Tractors Discussion Board |
Re: Farmall Magneto Points
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Craig on December 01, 2002 at 09:31:04 from (199.183.161.178):
In Reply to: Farmall Magneto Points posted by Jay P. on November 28, 2002 at 08:05:54:
Just changed the points and condenser on my A mag this week. My unit was converted to battery ignition but the points and condenser are the same. Mag points should be set to .013 but battery ignition should be set to .020. The condenser was a little tricky though. Remove the wire and unscrew the nut. Remove ovel shaped cover under the nut. Take off the top of the magneto covering the coil. Remove the hold down screw with the little metal clamp.The condenser will pull out from the top after you push the threaded part back into the housing. Hope this helps. Craig
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|