Farmall & IHC Tractors Discussion Board |
Re: H-Model Brakes covered in oil.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne Swenson on November 26, 2002 at 21:24:13 from (66.228.233.228):
In Reply to: H-Model Brakes covered in oil. posted by Geoffrey on November 26, 2002 at 19:22:19:
Be sure to put 2 seals on each side; the original seals were a wider leather type and today's seals just don't do the same job. Put some gun grease between the 2 seals for longer seal life. NOTE!! just pry and chisel and Vise-Grip the old seals out of the housing; I nearly made the mistake of trying to remove the housing without taking the gear off from inside the transmission. Take your time and the old seal will come out in several pieces. When adjusting the new brake bands, set them as equal as you can, connect the pedals together, set the brakes firmly and lock them in the applied position. Now adjust the setscrew on the bottom of the brake cover. Loosen the locknut and turn the setscrew in until it touches the brake band. Now back it out 1/2 turn and lock the nut. Repeat for the other side.This positions the band so it doesn't drag and wear prematurely. This can also help reduce brake "chatter". Enjoy!
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|