Farmall & IHC Tractors Discussion Board |
Re: international plows
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on November 25, 2002 at 15:50:54 from (209.226.247.53):
In Reply to: international plows posted by old fashioned farmer on November 25, 2002 at 08:04:16:
Is the plow rubber tired? I am asuming it is and likely a model 60 or 70. These models have the box beam somewhere around 4x6 that goes diagnol across the top of plow and the bottoms all bolt to it. If it doesn' have the box beam frame it will be one of the older plows. Older 4 bottom plows were 14, 15 and 16. Picture I have is not right clear but no 16 may have box beam also. The 14 and 15 definately do not have the box beam frame. Hydraulic cylinder mounts on the left front corner of the no 60 or 70. It is right on top and paralell with ground. The no 70 has 30" vertical and 26" horizontal clearence. I thought I had the clearance for no 60 it is slightly less both ways. I hope this helps, any questions ask.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|