Farmall & IHC Tractors Discussion Board |
Hydraulic Lift-all pump on M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Frank on November 23, 2002 at 20:46:50 from (216.117.100.231):
We have been trying to replace the lift-all pump on a Farmall "M" with a rebuilt pump. We have had a problem re-assembling the valve lever when we attach the pump to the reservoir. It is difficult to see when it is engaged properly. We thought we had it engaged properly but the pump will not automatically move to the neutral position when the lifting operation is completed and we cannot shift it to the neutral position manually. Any assistance would be appreciated by some of you that may have had this experience. Could it be that we do not have the valve lever engaged properly, or could there be a problem with a rebuilt pump that we purchased.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|