Farmall & IHC Tractors Discussion Board |
Re: Cost of Cub overhaul?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gauger on November 19, 2002 at 19:52:33 from (168.215.63.162):
In Reply to: Cost of Cub overhaul? posted by mgb on November 19, 2002 at 12:11:49:
Just finished one, rebuild kit was $479, included pistons, rings, pins, pin bushings, full gasket set, valves, guides, springs and locks, main and rod bearings. Machine shop was $550, bored block, turned crank, milled head, reconditioned rods and reamed and fit pins to bushings, ground valves, installed guides, cleaned and magnafluxed block and head. After the carb kit, plugs, tune up kit, oil etc. I have about $1100 in it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|