Farmall & IHC Tractors Discussion Board |
Re: Building a blade for a Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David A on November 19, 2002 at 16:31:55 from (12.155.101.39):
In Reply to: Building a blade for a Super A posted by marvin on November 19, 2002 at 11:48:40:
All the bracing is 1/2" except the "Y" shaped pair that lifts the blade which is 3/8". The plate that attaches to the clutch housing is 3/8". Good Idea to brace to the rear drive from the pivot. Around the pivot is the weak point. The downward "u" that the long pivot pin goes through tends to bend. The arm from the rockshaft to the lift point runs a little close to the side of the radiator. I'd leave more clearance, but keep in mind the headlight. Let me know if you'd like me to email a PDF copy of the A 60 manual. David
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|