Farmall & IHC Tractors Discussion Board |
Re: Re: cub oil pressure....HELP!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Coughlin on November 19, 2002 at 16:03:59 from (24.91.223.136):
In Reply to: Re: cub oil pressure....HELP!! posted by Jim in UK on November 16, 2002 at 17:16:35:
My family has a '48 Cub. It has the original "white" or soft metal cover on top of the oil filter. The asembly would sometimes loosen up and the oil pressure would go to zero. Tighten the bolt not too tight) and the pressure would come right up. An old Farmall mechanic told me that IH had changed to a cast steel cover because the soft ones were problematic. He said I'd have to replace ours someday. This was 35 years ago
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|