Farmall & IHC Tractors Discussion Board |
Re: Re: Re: will an M drawbar fit,,
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on November 18, 2002 at 20:41:38 from (65.239.44.32):
In Reply to: Re: Re: will an M drawbar fit,, posted by Hugh MacKay on November 18, 2002 at 03:19:49:
I use my two point to pull from. The only requirement was that It had to have some type of stabilization. The two point lift cylinder could be removed and a solid link put in its place. All my tractors have the two point and I use them regularly so I did not want to go to the hassel of removing the cylinder every time I went to a pull. I have brackets on the top of both axle housings and on each side of my two point that I place top links in. This lets me adjust my two point up or down as needed but is rigid.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|