Farmall & IHC Tractors Discussion Board |
Re: Farmall A Magneto / Rewiring Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Diesel Don on November 15, 2002 at 06:30:48 from (141.129.1.114):
In Reply to: Farmall A Magneto / Rewiring Question posted by Andy Kinard on November 15, 2002 at 06:03:28:
Just in case you didn't know,the serial number plate is under the seat on the left hand seat bracket looking at the rear of the tractor.As far as the mag,before you give up on it,remove the grounding wire that goes to the switch and then check for spark.That will eliminate a bad switch or grounding wire.If that doesn't help,lightly file the points and try it.If you can scrounge up a condenser you may want to try to replace it too.Try these things and if you still don't have spark,reply on this forum or e-mail me direct.I just finished rebuilding a mag for my A so I have a little experience with them.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|