Farmall & IHC Tractors Discussion Board |
Re: Front Snow Blade
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don on November 14, 2002 at 17:24:01 from (216.42.122.161):
In Reply to: Front Snow Blade posted by Andy Kopel on November 13, 2002 at 17:39:32:
I built a snow plow for our loaders. I used 2" square tubing for its main frame and then used 2 1/2" angle iron to make the 6' frame for the moldboard. I then cut a plastic barrel length wise and bolted these to the moldboard frame. Works nicely. The snow doesn't seem to stick to the plastic as much as it does to steel. I take the dump cylinder off the loader frame, as I have quick disconnects on these hoses, and then hook these hoses to a cylinder on the snow plow to angle the blade from left to right.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|