Farmall & IHC Tractors Discussion Board |
Re: Steering problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on November 12, 2002 at 18:48:20 from (63.171.43.140):
In Reply to: Steering problems posted by Brcye Andreasen on November 12, 2002 at 08:44:17:
Hey welcome to the club. I have been chasing the old wobble wheel on my 44 H all summer. here is what I did. #1 tightened the spacer that is at the steering post. 2 allen screws. #2 Tightened the worm gear sector. #3 rebuilt the upper bolster ( I did not replace the top bushing). #4 I had to replace the worm gear sector. I replaced with a used one. Every one of these steps improved the wobble. It is about 95% better but I still get wobble in 5th gear. I guess I should have replaced the top bushing in the upper bolster, but it looked good to me. guess not. That will be my next step. I show how I rebuilt the upper Bolster on my web site if you find that you need to do it also. good luck. Kelly
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|