Farmall & IHC Tractors Discussion Board |
Re: The latest purchase - W9
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don LC on November 12, 2002 at 12:10:47 from (24.166.248.35):
In Reply to: The latest purchase - W9 posted by Steven@nd on November 11, 2002 at 17:36:06:
Don't pitch that grill !!The mashed in grill can be saved..the bars are not damaged up and down,a good sign. the dents were pushed in and they can be pushed out..A good grill like that would cost over $200 if you could find one ......Build your self a simple fixture out of angle iron, that will fit the holes that fasten the grill on the trastor.....this will hold the basic shape of the grill.....weld angle iron, across the back of fixture...Now, straight behind the crease that runs from top right to bottom left,place a piece of 2"x4"on edge about 2"shorter on each end than the crease is long, round off the end, edges ....put a "PORTA PAR" against the 2x4 and strait back against the brace you welded on the fixture.....center it up......slowly begin to push out the large dent.....always push out a dent in the same direction that it was pushed in......Using pieces of wood you can push that grill into place,,,,to finish, use a body hammer and light strikes.....good luck...Don
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|