Farmall & IHC Tractors Discussion Board |
Source for 300U Safety flow control valve???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kirk on November 08, 2002 at 10:14:38 from (170.215.145.150):
My rebuild of the hydraulic system on my 1955 IH 300 utility came to a screeching halt this morning on initial sart-up when my safety and flow control valve popped a snap ring that holds one of the pistons in the casting. (Actually, nothing was screeching -- everything was VERY well oiled down!!!) On close inspection, my problem is that someone long ago has messed with the casting, leaving almost no groove for the snap ring to snap into. I put it back together with the snap ring in a different position and tried again, but same result. Does anyone know of a likely source for a good used valve? (The valve for my system is different than for a tractor without power steering. Mine has two fittings for flare nut oil lines coming out the back.) Any ideas would be greatly appreciated. Bob Kirk
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|