Farmall & IHC Tractors Discussion Board |
Re: f12 hyraulic pump gaskets
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F14 on November 07, 2002 at 04:09:52 from (216.204.137.72):
In Reply to: f12 hyraulic pump gaskets posted by luke on November 06, 2002 at 18:37:45:
They're dead simple gaskets to make. I made ALL my own gaskets for the pump. In fact, except for the few that I got from NAPA for the engine (Valve cover, cylinder head, oil pan, crankshaft seals and couple others) I made all my own gaskets for the whole tractor. Not hard, and a good deal faster (and cheaper) than screwing around trying to find pre-mades. A set of gasket punches would be nice, but with a new blade in a utility knife and a little inventiveness, you can make your own. For instance, straight-wall pistol cases (such as a .38 or .45 caliber) make purdy good hole punches...
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|