Farmall & IHC Tractors Discussion Board |
Re: Re: Beginner on M's
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nick Williams on November 03, 2002 at 05:59:15 from (206.139.2.26):
In Reply to: Re: Beginner on M's posted by Charlie on November 03, 2002 at 05:45:57:
Charlie: Thanks for the post.. I've noted the two outlets on the left and the one on the right. I am so new to this, however I rode with my grandfather as a child on his Ford tractor and I rememember the powerlift would not work until the clutch was released. I assume this is the case with this belly pump as well. I read somewhere that some people are mounting a hydraulic pump between the distributor and the engine. If that is the case, it would seem that would be active all the time. This cylinder on the left side seems original. I'm wondering if it will apply pressure both ways. Again I'm new to all this. Thanks for your patience. Nick
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|