Farmall & IHC Tractors Discussion Board |
Re: Live Hydraulic Pump for H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on November 01, 2002 at 10:00:57 from (165.234.130.25):
In Reply to: Live Hydraulic Pump for H posted by Chris on November 01, 2002 at 08:37:20:
This has been discussed several times. The live pump will fit your H, BUT you need the timing cover from SH/300/350 to make it fit right. You should also switch the cam gear to 300/350 because they are built heavier for the increased load. As for the plumbing, I have a diagram for where to drill a hole in the belly pump reservoir for suction, I can scan it and email it to you if you like - email me if you want it. I think the original drain plug for the reservoir is too small to allow enough oil to get through for the pump. Then from the pressure side of the pump go to your spool valve for hydralic control, be sure it is open center. Return from the spool valve can go right back into the suction line (at the belly reservoir), I would plumb it in with a T in the line. Ask more questions if you need clarification, people here are happy to help!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|