Farmall & IHC Tractors Discussion Board |
IH 2606 industrial (front end rear main seal)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Howard on October 31, 2002 at 16:10:54 from (24.53.5.144):
I would like to ask a question about a 2606 IH if i may .im not good with computers an my wife hasent had time to do the email setup that is why i have none . i just purchased a 63 IH industrial 2606 with a IH 3000 loader .the rear main is leaking preaty bad it is coming out between the block and trans bellhousing. i have manuals coming but was curios to how hard this tractor is to split . and do i have to pull any thing off but the clutch and flywheel is the seal like a wheel seal or different .the front end end needs help to. the king pins or spindles have been welded in to turn with no bearings so the holes are oblong . are the spindles avalible and can i bring the tront end to a machine shop to have it sleaved to except a new spindle or bearings. i dont know what should be like because it was patched up.not a bad tractor for what i paid .any body else would probley just run it but its to good to leave all messed up thanks for any help Howard - salisbury mass
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|