Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Farmall 200 vs. Farmall C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jal-SD on October 31, 2002 at 06:19:45 from (64.68.166.199):
In Reply to: Re: Re: Re: Farmall 200 vs. Farmall C posted by Dave_Id on October 30, 2002 at 16:30:46:
When you slide the wheels, it works a LOT better if you turn the wheel so the movable part of the clamp is on the bottom, with the "split" on a horizontal plane. You'll want about 1/4" of drop between the clamp & the axle. Oil the bottom half of the axle, (be sure to get inside the space between the axle & clamp) turn the wheel so the clamp is on the top, oil again between the wheel & axle, turn the wheel so the bolt heads are up & wiggle on top & bottom. BE CAREFUL, when they start, they go EASY & you can push the wheel off the end of the axle in a heartbeat. DON'T EVEN ASK how I know that this can happen! (My $0.02 worth. jal-SD)
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|