Farmall & IHC Tractors Discussion Board |
Re: Plugs
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F14 on October 28, 2002 at 14:18:05 from (216.204.137.117):
In Reply to: Plugs posted by waynetom on October 28, 2002 at 09:20:29:
The plug above the worm gear is to add gear oil to the steering box. I'd assume the plug above the PTO is to add gear oil as well, but I'm not familiar enough with a B to say that for sure. Dropping the pan will get you a good look at the bottom of the sleeves, and if the engine is not stuck, you rotate it and see much of the cylinder walls. Look for water in the oil when you drain it, that's evidence of a crack or a leaking sleeve seal. If the block is cracked between the sleeves, you may or may not be able to see that from the bottom. My limited experience indicates that cracks between the sleeves are common on the top (deck) of the block, don't know about underneath.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|