Farmall & IHC Tractors Discussion Board |
Re: Re: Re: a question for red rider
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on October 25, 2002 at 19:56:05 from (65.239.11.126):
In Reply to: Re: Re: a question for red rider posted by carl on October 25, 2002 at 17:13:50:
If you H is stock it came from the factory with 152cu. The gas version had 25.5 draw bar and 27.9 pto/belt. This is what I would do. I would bore your block to except the 3 5/6 sleeve and stock flat top pistons for a Farmall 350. Use the Cam and intake/exhaust off a 300/350. Use the 350 propane head. You could also take the head and intake/exhaust manifold to a professional head rebuilding shop and have the ports matched and cleaned up. You could also have your carberator rejeted. The LP head and flat top pistons will get you 9.1 compression ratio. This is what I have done to my 300 Farmall and it will turn the dyno to 50 HP at 2000 RPM
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|