Farmall & IHC Tractors Discussion Board |
Re: 1566 hydrolic ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scottAR on October 20, 2002 at 06:26:14 from (209.194.159.174):
In Reply to: 1566 hydrolic ??? posted by Fred on October 19, 2002 at 19:25:33:
More than likely the arm that senses draft has come disconnected. It's not much problem to repair unless you are out in the middle of a field with four bottom flip over plow hooked up because the first thing to remove is the top link door on the back of the main case. You can use a long loop of wire to pull on the arm sticking down from the rockshaft valve and the hitch will go down. The problem is caused by the arm that clamps to a flat place on the draft shaft has come loose and shifted to one side letting the rockshaft arm flip by and go to full raise position. To tighten the lower arm, you will have to drain the hydraulic oil, or drive the front of the tractor into a ditch about three feet deep, then slide the power take off assembly out on the drawbar and tighten the "muffler" clamp that holds it in place.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|