Farmall & IHC Tractors Discussion Board |
Re: Re: worksaver
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP on October 18, 2002 at 18:17:38 from (216.46.197.240):
In Reply to: Re: worksaver posted by mwkellner on October 18, 2002 at 09:16:12:
I have the same setup on my 200 as mwkellner. Works fine - picks up 8 1/2 foot disk that must weigh close to 900#. Easily handles heavy built 2 bottom plow. Have used a heavy 5' brush hog, and 7' sickle bar mower, as well as a 3pt hitch hay rake. Only problem has been when I used a dirt scoop, and tried to work too deep. Tended to buckle on the 3point hitch, and jam the top link into the pto shaft. If you don't have 2 pt to convert, suggest you look for setup with it's own cylinder(s).
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|