Farmall & IHC Tractors Discussion Board |
Re: Re: worksaver
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP on October 18, 2002 at 18:17:13 from (216.46.197.240):
In Reply to: Re: worksaver posted by mwkellner on October 18, 2002 at 09:16:12:
I have the same setup on my 200 as mwkellner. Works fine - picks up 8 1/2 foot disk that must weigh close to 900#. Easily handles heavy built 2 bottom plow. Have used a heavy 5' brush hog, and 7' sickle bar mower, as well as a 3pt hitch hay rake. Only problem has been when I used a dirt scoop, and tried to work too deep. Tended to buckle on the 3point hitch, and jam the top link into the pto shaft. If you don't have 2 pt to convert, suggest you look for setup with it's own cylinder(s).
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|