Farmall & IHC Tractors Discussion Board |
Re: fair price for a 300
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave_Id on October 16, 2002 at 08:13:23 from (67.250.102.176):
In Reply to: fair price for a 300 posted by Bill Weber on October 15, 2002 at 22:18:13:
I paid $1800 for a 300 with a wfe... metal wasn't that hot... needed a carb..had a good TA.... I installed a Saginaw 3 point..and I just loved that tractor.. It was a perfect second tractor for me... I used it extensively with a 5 ft tiller.. using slow first gear. The only thing that I didn't like was the fact that I had to take the brakes apart every year and clean up the rust. I had too much condensation inside the brake housings. The hydraulics didn't work with my round baler...leaky seal on the pump which I repaired, but still the oil leaked off, and the baler unlocked, and door opened on me...
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|