Farmall & IHC Tractors Discussion Board |
Leaky Hydraulic on Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan England on October 11, 2002 at 04:31:29 from (65.164.183.204):
Hydraulic fluid in my super A leaks into the crankcase. I haven't worked on hydraulic systems before and I need some info before I start. A. Can I access the pump by disconnecting the metal hydraulic lines at the pump end only or must they be disconnected at both ends to move them out of the way. B. Can I make the repair by removing only the pump cover or will I need to remove other parts within the pump. C. I have two rubber 0-rings, one oil seal and one fiber gasket. I assume that all of these will be needed at the pump. IF the hydraulic lines have to be disconnected at both ends will an additional gasket be needed there. D. I will appreciate any additional information you can give me. Thanks, Dan
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|