Farmall & IHC Tractors Discussion Board |
Clutch pedal SM-TA?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark R (NY) on October 07, 2002 at 17:17:02 from (152.163.189.203):
I've never installed a new clutch, so I'm not sure specificly about the question I'm about to ask. But a few day's ago I had a new clutch installed in my SM-TA. Well now since then my clutch pedal travels about 2" before it disengages the clutch, where as before it was like 3/4". I got used to the quicker response when I pushed the pedal and think it should be that way or even better with the new clutch. Am I wrong? The guy who did the job said it's now the way it should be and that before it was wrong. He said that before the throw out bearing was to close to the clutch face, and that there should be 1/8" clearance. Is he right? Maybe I can learn more after some input, Thankyou to anyone who responds. Mark R
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|