Farmall & IHC Tractors Discussion Board |
Re: Engine blocks
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bud barenie on October 03, 2002 at 05:32:27 from (65.173.202.149):
In Reply to: Engine blocks posted by farmallflogger on October 02, 2002 at 09:48:32:
the 264 and 281 blocks came after the 247 block! probably not considered replacement!! because they were newer models. they could have been swapped. the 264 block started in the super (m)s 1952. only in tractor pulling would some one complain !!! if they only new the base difference!! the 264 block was 264cid, 4" pistons the 247 block was 3-7/8 and there was an upgrade to 264, i reckommend grinding the number 264 of the block !!! and say you changed it !! or ask where it says in the rule book why a 264 block in your m can't be used !!! i'm in the process of building a 1946 (m) probably going to use a 264 block!!!! but i'm going to grind the numbers off and have a tag made with my last name on it !!! will see how that flyes !!!! good luck !!! happy pulling !!! and enjoy the sport !!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|