Farmall & IHC Tractors Discussion Board |
Re: Painting a Super A?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on September 30, 2002 at 18:41:25 from (207.178.96.214):
In Reply to: Painting a Super A? posted by SAm in NS on September 30, 2002 at 15:11:02:
Remember that paint highlights defects. Any dent or scratch will look WORSE after you paint. Dents need to be filled (I assume you have done this), sanding scratches finer than about 180 grit can be covered with a primer surfacer, followed by sanding with 400 grit or finer. If you have numerous small imperfections in any of the sheet metal, PPG and Dupont make sprayable body fillers, that can be sanded and then covered with primer surfacer. If you are down to bare metal, the 1st coat should be either an etch primer or an epoxy primer depending on what kind of rust converter you use. It all depends on how good a job you want. If you want a really good job, you might want to post this question on the paint board. A couple of very knowlegeable people should answer.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|