Farmall & IHC Tractors Discussion Board |
Re: Old Raceway M-Minor Setback
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zonie on September 29, 2002 at 21:24:01 from (198.81.16.159):
In Reply to: Old Raceway M-Minor Setback posted by The Red on September 29, 2002 at 09:58:04:
Sounds to me just about the same as my H was running shortly befor I ended up with a knocking bearing. Check out the rod and main bearing clearances. It's a lot cheaper to replace bearings, and easier than waiting till you have to get the crank turned. When I overhauled My H I did surface the bottom plate on the oil pump as some otherss have mentioned, by using the plate glass and very fine grit emory cloth, worked great! If you do this make sure you put even pressure over the entire plate. Good luck, John
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|