Farmall & IHC Tractors Discussion Board |
Re: 66 series cab removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on September 29, 2002 at 04:35:09 from (216.208.58.128):
In Reply to: 66 series cab removal posted by K.B. on September 28, 2002 at 21:37:45:
I have never actually removed one of those cabs. I have seen it done and when complete all you need is mounting steps and fenders. If you put lights in fenders your harness will need to be lengthened. The platform under your cab is the same as the open station tractor. There are also handle grips used in mounting tractor that wrap around TA lever on one side and the shift levers on other side. Those could allready be on tractor. I have also seen the mounting steps on side of chassis there with a cab. My 1066 did not have them. Batteries mount differently on open station, been awhile since I looked, not sure on that one just where . I did mount one the Excel cabs used on early 66 series and 56 series, on a 656. The cab I used came from a 1066. Because chassis of 656 is different from the larger tractors I had to fabricate my own mounting brackets at axles and on side of tractor at front of cab
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|