|
Farmall & IHC Tractors Discussion Board |
Re: HELP!!! Putting the duals on the Super M for the show!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on September 18, 2002 at 18:28:55 from (24.169.120.138):
In Reply to: HELP!!! Putting the duals on the Super M for the show!! posted by Tim Malin on September 18, 2002 at 17:57:03:
Tim - I gonna presume your 2nd set of tires has standard cast iron wheels - same as the wheels on the tractor now. To install the 2nd set: 1 - If the inside wheels are set concave side facing toward the tractor, you must swap 'em so they're mounted concave facing OUT (away from the tractor). Slide the wheels in almost as far as they will go - but leave 1/4" or so of clearance between the hub and the axle housing. Now tighten the all 4 clamp bolts down on each wheel. 2 - Now install the outer duals on the axles, again with the concave sides of the wheels facing out. 3 - You can now tighten inner pair of the outer wheel clamp bolts using a suitable rachet handle, extension and socket inserted thru one of the holes in the outer wheel casting. Be sure to draw down and tighten all (4) clamp bolts gradually and evenly on each wheel so they don't cock or bind!! Also re-check all the clamp bolts for tightness after the tractor has been run a mile or two. Have fun at the show!
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
