Farmall & IHC Tractors Discussion Board |
Re: Broken Head bolts on my Lo boy???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on September 14, 2002 at 16:40:49 from (216.46.130.12):
In Reply to: Broken Head bolts on my Lo boy??? posted by Ron in NJ on September 13, 2002 at 17:39:59:
Ron you have a tough row to hoe but it can be done. Getting broken studs out requires a good sharp center punch a set of sharp drills and a good set of easy outs. I prefer the square shank easy outs as I believe the bite in better than the spiral ones. Getting the punch in exact dead center is important and drilling , starting with a small drill and increasing the size up to the size of your easy out. Tap the easy out in with a sharp blow and start turning...don't be afraid to use some heat around the area of the broken stud...hopefully you will feel it break free and begin to turn...soak with penetrating oil before you begin the task...the night before..don't be afraid to drill larger and larger holes to get the bigger easy outs in...you can tap out the hole after even if it is burred and restore the thread. You need lots of patience, don't hurry..each bolt out is a moral victory..good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|