Farmall & IHC Tractors Discussion Board |
Re: Re: Going to tear down the 706 gas - advice appreciated
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Larry F on September 08, 2002 at 22:11:17 from (216.202.132.34):
In Reply to: Re: Going to tear down the 706 gas - advice appreciated posted by andy - more on 706 problem on September 08, 2002 at 21:49:49:
Andy - I'm not real familiar with the 706 but 250-300 hours on a gas engine with new pistons and sleeves doesn't sound like alot of hours to be burning that much oil. If one set of rings went bad you'd be fouling the plug in that one cylinder but sounds like all of your plugs were fouling and I doubt all six sets of rings went bad at the same time. My suspicion is your problem is in the head. Perhaps bad valve guides (don't know if the 706 uses valve seals). An engine will burn a surprising amount of oil from the top end - had an old Harley that went thru a quart every 1000 miles from the worn valve guides (no seals). Another thought, if the engine wasn't properly broke in when it last had new pistons and sleeves installed that can cause an engine to burn oil prematurely but you likely would have noticed it burning oil all along.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|