Farmall & IHC Tractors Discussion Board |
Re: McCormick W6
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by caseman-d on September 08, 2002 at 16:28:03 from (63.121.189.241):
In Reply to: McCormick W6 posted by 44 on September 08, 2002 at 16:07:30:
I have 16.9-30's on my W-6. Guess all depends on what weight class you want to pull in. I have pulled in the 5500,6000, and the 6500 lb classes. I have pulled the front end off the ground in the 6000 and 6500lb classes. Seems to also have good power as I spin out most of the time. I however powered out the other day in the 6500lb class. Sometimes I do good and other times not so good. Thought of trying some 18.4-30's but looks like I'll have to remove the fenders. Also power may be a problem. A SW-6TA may handle 18.4-30's. Think if I found some good 23 degree tires would help. Doesn't matter if I win, I'm there to have fun. caseman-d
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|