Farmall & IHC Tractors Discussion Board |
Re: Farmall 100 Help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Glenn(WV) on September 01, 2002 at 18:20:09 from (67.201.149.198):
In Reply to: Farmall 100 Help posted by jerry on September 01, 2002 at 17:34:54:
Are you using the right weight of oil? The manual calls for straight 30-weight. My 100 had some type of multigrade in it(my uncle had done the previous oil change) and it did exactly what yours is doing - it would go to about 25-28psi cold and drop to about 10psi hot(sometimes less). I replaced it with straight 30-weight and the pressure improved by 10psi cold and 7psi hot to 38 cold and 17 hot. As for the seat, what you have described is not original. The 100 came with a pan seat that was supported by two leaf springs. There was an optional "deluxe" seat with a seatback and armrests that slid on two rails for adjustment.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|