Farmall & IHC Tractors Discussion Board |
All set to mow and now tractor stalls
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gramps544 on August 27, 2002 at 05:15:20 from (64.105.216.218):
I have a 1968 International C200 engin gas (4 cyl). It was running fine the begining of this summer. Now after about 20 mins of work it stalls. Espically when running at lower RPMS. After it stalls it will not restart unless the choke is all the way closed. Then after it starts with the choke slightly open it will run for about 10 sec and die. If during this 10 sec I advance the throtle all the way, all kinds of black smoke comes out and it seams to be misfiring. IF I wait about 2 hrs, I can repeat this whole cylce. Since I have to choke it to start I think it is running to rich and getting flooded. What do you all think and how would you go about correcting the problem. Also could the main jet in the carb be causing any of this problem. I have it opened quite a bit ( my manual said it could not restrick any flow or problems would arise). Any help would be greatly appreshated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|