Farmall & IHC Tractors Discussion Board |
Re: Engine seized on newly purchased farmall super C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on August 24, 2002 at 14:10:49 from (216.46.130.32):
In Reply to: Engine seized on newly purchased farmall super C posted by Murray on August 24, 2002 at 13:46:55:
Murray , get the spark plugs out and get penetrating oil down the cylinders. With the tractor in gear, rock it back and forth this will allow piston movement without pushing the piston all the way through its cycle in a rust an corroded cylinder wall. By moving back and forth the piston will clear its own way through the cycle a bit at a time. Some suggest jacking the rear wheels off of the ground and rocking a rear wheel back and forth. Be patient it may take days but keep the penetrating fluids in the cylinders. Many people on this line recommend a product called PB Blaster which is supposedly a good penetrant...don't bother with WD40. I always figure a siezed engine is better than one so loose there is no chance but a rebuild. If you are lucky it may break loose ...the down side is pulling the head and dropping the caps on the bottom end and pounding the pistons out but that's a story for THE RED to tell you about. Hopefully you will be able to take the easy route.Keep us informed on the forum and good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|