Farmall & IHC Tractors Discussion Board |
Boil block with sleeves in it?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by WIRED on August 23, 2002 at 08:56:40 from (156.46.176.113):
I've got a 1941 H that I'm redoing. The cylinders are within spec, and the pistons appear fine. I want to have the block boiled to remove 50+ years of accumulated gunk, so that I can run modern multi-viscosity detergent oil in it after the rebuild. My question to the board: is it necessary to remove the sleeves prior to boiling the block? My local Case IH dealer wants to charge about $50 to remove the sleeves. If I pull 'em out, I'm probably looking at replacing sleeves and pistons, so my rebuild cost is going to be about $400 higher than replacement of rings and bearings alone. Thanks for your thoughts on the matter. Head is in the machine shop right now. When done, this tractor will not be a daily worker -- more of a weekend warrior. WI Red.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|