Farmall & IHC Tractors Discussion Board |
Re: IH 1206 eng.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on August 19, 2002 at 15:58:55 from (216.196.13.181):
In Reply to: IH 1206 eng. posted by Mark on August 19, 2002 at 10:42:51:
If the old girl is getting tired then give it a ovehaul , but when ya do this it must be done with great care as this is not and engine that can just be throwen togeather as it's age has made some core shifts in the block and it is wise to have it bored .010 and install the over size sleeves and if i was doing it i would take it to someone that can set up off the mains on a big boreing bar that way you get all the sleeves in line and a good line bore also don't hurt as for the power well i don't think that after a good breakin that 160 to 170 is not out of the question and a good pyrometer to watch the temp. And if this is not enough then go find a good old 1066 and set it like i have a buddy's set we have no problem choppen corn in 4th low with the stick ahead and my old 806 with no charger on it will run the same chopper in 2nd low stick ahead.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|