Farmall & IHC Tractors Discussion Board |
Re: S/M TRANNY
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr. Evil on August 19, 2002 at 14:19:48 from (12.4.181.2):
In Reply to: S/M TRANNY posted by BOBBY on August 18, 2002 at 17:15:39:
BOBBY - There's a pin under the cover on the gearshift lever...it runs side-to-side, left to right as You sit on the tractor... it has a steel plug pressed into a bore about 1/2" to 3/4" dia. and You have to poke a hole into one of those covers if there isn't a hole already. If there is a hole use a punch and beat the pin out the other side thru the hole. Lift the gearshift up out of the transission and them align the notches in the shift rails like JOE says. His 460 is newer and the gearshift mount is bolted on. Your Super M it's cast as part of the top cover of the transmission & rear end. When the rails are lined back up set the gearshift down into place again and slide the pin back into place... and tap the hole plug back in if possible.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|