Farmall & IHC Tractors Discussion Board |
Re: How Much Paint Does It Take?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on August 16, 2002 at 18:22:52 from (64.12.102.52):
In Reply to: How Much Paint Does It Take? posted by RedTed/MO on August 15, 2002 at 17:53:07:
Just recently finished painting a "B". Not a lot of difference between it a an "H" just a little bigger. I also painted a 7x8 trailer and a few extra other parts. I had painted the front of the engine when I had the unit apart. I had a gallon of paint and a pint of hardner also used about a quart of thiner. Painted it all once and let it get tacky and then painted it again the second time. I had atleast a quart of thined and mixed paint left over. Don't mix all of your paint at one time. The hardner will start to set it up and you will end up waisting what you haven't used. I would mix 2 quarts and see how far you go and that will give you a good measure. Air pressure varys with different spray guns. I have one that uses only 35lbs and another newer one that used 70lbs. I recomend a paint pot and supply lines and paint gun rather than a paint gun with quart container attached. With the pot and gun it is possible to paint in any and all positions and of course you can go a lot further, also you can mix your paint right in the pot. Mine is 35 years old and still going great. Several light coats is much better than one heavy coat of paint. The successfull paint job is the one that has had the best prep job (no subsitute for this). NOW GO FOR IT---------GOOD LUCK
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|