Farmall & IHC Tractors Discussion Board |
Re: hydraulic problem on 300U
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on August 12, 2002 at 21:08:04 from (65.239.44.148):
In Reply to: hydraulic problem on 300U posted by Charlie on August 11, 2002 at 18:08:47:
It would be to your advantage to get the hydratouch manuel. On the 300/350U you really have to plump the second and third valve correctly. They have to receive their hydraulic supply through the regulator valve. There is suppose to be a plate that bolts to the hydratouch valve that bolts to the regulator valve that is tapped for half inch pipe. Where you bolt the second/third hydratouch valves the presure port is pluged. The outer plate for your second/third valve is also tapped for half inch pipe. This will allow the hydraulic pressure for the second/third valves to come through the pressure regulating valve.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|