Farmall & IHC Tractors Discussion Board |
Re: 12 volt alternator wiring
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug in OR on August 10, 2002 at 19:10:55 from (12.225.49.173):
In Reply to: 12 volt alternator wiring posted by Hal Davis on August 10, 2002 at 17:52:22:
You can buy a single wire 10SI. Installation is a bit more simple. That's on the plus side. The two negatives are: 1) A single wire alternator will cost more $$$. 2) A single wire alternator generally needs more RPM to start charging than a conventional 10SI alternator. On a tractor, extra RPM is harder to develop. To wire a regular 10SI, you can put the light in if you choose. If you don't want the light there, you can substitute a diode (usually a 1N4001 or such) and a 47 ohm, 2 watt resistor. Tie the resistor and diode in series. Have the "band" side of the diode facing the alternator #1 connection. The beauty of a conventional 10SI is that they can be had at many junkyards for about $10. Maybe even as much as $39, rebuilt, at an auto parts store. You'll pay maybe $79 or more for a good single wire alternator.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|