Farmall & IHC Tractors Discussion Board |
Re: Re: Re: IH 314 Plow
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on August 06, 2002 at 15:28:20 from (209.226.106.33):
In Reply to: Re: Re: IH 314 Plow posted by MD Wa on August 06, 2002 at 07:59:08:
From the description you give I would say you have a model 70 plow. Are you sure it doesn't have trip beams. It would have large pin for pivot point about 4" above moalboard on beam. Spring latch is up near top just under plows main beam or the square tubing that ties all 5 bottoms together. If it doesn't have trip beams it will surely have a trip hitch, coil springs on plow pull bar, probably about 4 of them for a 5 bottom plow. The trip hitch does not work that well on big plows One of my 4 bottom No.60s had that trip hitch. I found if you had enough spring tension to pull plow, it would not protect individual bottoms.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|