Farmall & IHC Tractors Discussion Board |
Re: BN Draw Bar
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on July 29, 2002 at 20:16:12 from (151.202.185.143):
In Reply to: BN Draw Bar posted by john on July 29, 2002 at 19:22:58:
John, the way the drawbars mount between the final drive housings on the As and Bs, the basic difference between them is the width so, if you can't find an original somewhere, the middle ground between that and homemade is to add some metal to an A drawbar or cut some (about 8")out of a B. Then your biggest concern will be to get some new holes in the right places. If you're doing a swinging drawbar, the original of both the front crosspiece and the tongue are such that you could do or have done a real good fabrication without too much trouble. Try checking the archives here, too. I seem to recall geneb checked in with some good info on a similar question about a month ago.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|