Farmall & IHC Tractors Discussion Board |
Re: Re: Re: to Scotty(NY)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on July 23, 2002 at 10:47:36 from (128.59.123.240):
In Reply to: Re: Re: to Scotty(NY) posted by ricahrd on July 23, 2002 at 08:04:50:
Right you are! That's the only way to get to that one. And that's a tough place to split as there isn't any real good place to block anything firmly. It's not too hard to roll the back away, but, even with a hoist, there isn't any real good place to block the front up. You can use the low spot in the bell, but you have to chock the front wheels AND get some wedges in them so that they don't turn. You can flip the whole front end if it gets nudged hard enough. There was a thread late last week (sorry I can't recall the heading) about someone running long bolts into the cultivator mounting pads on the front end and getting jack stands up under them. That helps, but you still have to be plenty careful, especially when putting things back together--that's when the big bumps can happen.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|