Farmall & IHC Tractors Discussion Board |
How do I tell what bearings are bad?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by richard on July 22, 2002 at 11:06:44 from (199.131.159.125):
My A rear end is noisy and I can feel the drive shaft or gears inside when i am driving it. I have been listening to it long enough to think that it's noiser than a normal noise for a Farmall A rear end. How hard is it to split the tractor? Do I need special supports to split it and change drive shaft bearings? And, can I do this myself if I get a hand from someone who is willing to help? Is it a job for an experienced tractor mechanic or can I do it if I am careful? I need to replace the rear end bearings...so I am thinking/// But I can't tell for sure/ Advice and help is needed to help me narrow down the problem before I split it. thank you
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|