Farmall & IHC Tractors Discussion Board |
Re: 706 two point hitch spongy
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by smotch on July 21, 2002 at 15:03:51 from (65.164.112.183):
In Reply to: 706 two point hitch spongy posted by bryan on July 20, 2002 at 09:50:17:
Bryan, Remove the plate at the back of the tractor to gain access to the sensing arm and make sure that the draft sensing arm is in the right position. The lever from the rockshaft cover goes behind the arm that comes up from the torsion bar at the bottom of the differential case.If this is in the proper place turn the sensing arm adjusting screw clockwise3 to 4 turns place the draft control lever 2 7/8 inches from the rear slot of the quadrant, move the position control lever to the lower position (at offset in quadrant)Start engine and turn adjusting screw counter-clockwise until the hitch raises The hitch will raise all the way . tighten the set screw and replace the cover .
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|