Farmall & IHC Tractors Discussion Board |
Re: Ford 881 Select-o-matic
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan Robertson on July 21, 2002 at 11:43:00 from (66.244.83.66):
In Reply to: Ford 881 Select-o-matic posted by Joe on July 21, 2002 at 10:00:58:
Joe, you should probably post this question over on the Ford discussion board for more responses. I do follow both boards since I own both makes including a 2000 Ford SOS. My guess is that the torgue-limiting clutch has failed. this requires an engine/transmission split to repair. Check your PTO to see if it will still pull a load. If not, then remove the transmission fill/oil level plug down on the right side near the front of the tranny. With engine at idle look into the hole for signs of fluid movement, and or moving parts. Nothing moving is a pretty sure sign of torgue-limiting clutch failure. I had it happen on mine. Dan Robertson
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|