Farmall & IHC Tractors Discussion Board |
Re: Re: 52 super m
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jayme on July 20, 2002 at 13:05:43 from (207.179.180.76):
In Reply to: Re: 52 super m posted by The Red on July 20, 2002 at 09:58:48:
How much is a super m worth? wide front,ok rubber,stuck engine(ran last year) converted to 12 volts,ok tin work,needs some tlc it has a hydraulic valve behind the belt pully and another one added on infront of the headlight support, i dont know what the tranny is like, but the resevoir is bolted under the clutch housing and is about 12" square and 10 " high , I will see if I can get a picture soon,I am busy with haying. the carb butterflies are also stuck. How does the throttle control work,looks to me like there is a rod that runs fron the control to the thing (goveroner?) infront of the carb and there is a 1" Tube that runs from the goveroner back to the top of the carb. is this more complicated than it looks?
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|